Motor Control Products
Motor Controllers for
OEM Designs welcome
Features_________________________________
 |
Utilizes
Hitachi ECN3030F motor controller chip |
|
Built-in
power supply, 90-130 VAC / 50-60 Hz Input |
|
For
¼ to 1¼ HP motors, 3-phase Delta/Wye windings |
|
Shaft
speed range from 10 to 12,000 rpm |
|
IGBT
power transistors allow up to 13A continuous current operation |
|
Microprocessor
controlled for maximum versatility |
|
Programming
connector for In-circuit programming of processor |
Hardware
-
Thermistor monitor with programmable limits for heatsink temperature
-
Hall sensor input connector with 7.5 VDC power for Hall sensors
-
AC input transient protection and in-rush current protection
-
LED status light under programmable control
-
Transistor over-current protection on-board
-
High Voltage on/off under software control
-
Post jumper calls self-test or other custom software utility
-
Custom Hall sensor board design available
Software
-
PID velocity control loop software available, custom loop tuning
-
10-bit PWM control of motor speed
-
RS-232 Serial port connector for control and status information I/O
-
Front panel speed control and Fwd/Rev switch available
-
Custom programmable acceleration/deceleration profiles
-
Thermistor monitor with programmable limits for heatsink temperature
-
Software generated Hall-sensor simulation for testing without motor/Hall sensors
-
Regenerative braking for low mass loads
-
Custom burn-in hardware and software available
Mechanical
-
Compact 3”W x 6”L x 3”D size
-
Standard ¼" Faston connectors for motor leads, and input power leads
-
High quality multi-layer circuit board
-
On/Off switch pads on-board
-
Rugged 1/4” thick aluminum heatsink mount allows a variety of add-on heatsink
-